The ramp consists of three honeycomb-type metal panels that are joined with hinges to fold and unfold. One of the advantages of this ramp is that the use is completely manual, which is simple, easy and safe. This is the best option for those vehicles whose ground is a little high and space is limited.
The ramp is made with aluminum profiles and honeycomb panel. We apply this panel for its advantages in terms of anti-slip, limited weight, high load capacity and other suitable characteristics. Hydraulic springs are arranged on both sides of the ramps that make their use easy and prevent the ramp from unfolding itself when the emergency brake is set.
There are two support supports under the second ramp which ensure its stability.
Size of the platform(LxA)
Posición de Instalación
Measures in millimeters
2240 x 810
Installs on the side or back door of the vehicle
2700 x 810
3300 x 810
3900 x 810
The ramp is operated manually which is safe. There are two hydraulic springs on both sides of the ramp, which help and make the use easy. There is a fixing screw in the lower part of the ramp (see figure 4) that can ensure that the vertical ramp in case it is going to be stored without use. Also this screw will prevent the ramp from unfolding itself. It is an extra security equipment.
This is the best option for those vehicles whose ground is a bit high and the space is limited.
Van or minivan, on the side or rear door of the vehicle Technical characteristics Lifting capacity: 350 kg Standard dish depth: 2240-3900 x 810 mm Plate widths: 880 mm Indications of adequate weight: 350 kg
This is a custom block edited from admin panel.You can insert any content here.